The new version 1.0.8 does not work well with EIS, so if you want stabilization you can install this previous version.
Follow these steps to install the firmware v1.0.5:
1. Download the attached file and extract the contents from the zipped file
2. Copy the firmware in your SJcam's micro SD card (root directory- not within any folder)
3. Copy the firmware file FWxxxx.bin to your Micro SD card, and make sure you have at least 50% power on your camera's battery.
4. Turn the camera on, and the installation process will begin.
5. Once done, the camera will restart into the new firmware.
6. Format the card to make sure the installer file does not load each time you power it on.
You may verify that the new firmware is installed by going to General Settings > Version
Click here to download SJ8 PLUS stable Firmware
Follow these steps to install the firmware v1.0.5:
1. Download the attached file and extract the contents from the zipped file
2. Copy the firmware in your SJcam's micro SD card (root directory- not within any folder)
3. Copy the firmware file FWxxxx.bin to your Micro SD card, and make sure you have at least 50% power on your camera's battery.
4. Turn the camera on, and the installation process will begin.
5. Once done, the camera will restart into the new firmware.
6. Format the card to make sure the installer file does not load each time you power it on.
You may verify that the new firmware is installed by going to General Settings > Version
Click here to download SJ8 PLUS stable Firmware
No comments:
Post a Comment
Hi, we hope you find this content helpful. For any suggestions and recommendation please comment below. We value your feedback.